We defined the interfaces between the air/snow, snow/ice, and ice/ocean and calculated the ocean heat flux for two SIMBA recordings (SIMBA2015a and SIMBA_2015f) of repeated temperature profiles at 6h interval and 2cm vertical resolution, during N-ICE 2015 experiment floe1. - The snow/ice interface is derived from the sharp contrast in the diffusivity proxy values between both media. The snow/ice interface does not change except for slush formation associated with flooding events. - The air/snow interface is calculated using simultaneous information from the vertical gradient of the temperature and the standard deviation over 24, 48, and 72 h period. Snow accumulation of more than 10 centimeters happened at different time for the 2 SIMBA. - The ice/ocean interface is estimated from temperature profiles alone since the winter sea-ice remains colder than the ocean. The ocean just below the ice is at or just above the freezing temperature (estimated from a near surface conductivity-temperature-depth (CTD) sensor see Koenig et al. [2016]). The method detects (1) the first sensor, downward of the snow/ice interface, with a temperature above the ocean freezing temperature and (2) the last sensor in the ice with a temperature below the mean ocean temperature by at least twice the ocean temperature standard deviation in that profile. The ice/ocean interface is then defined as half way between the last sensor in the ice and the first sensor in the ocean. Note it take 3-4 days for the deployment hole to refreeze. Then the ice thickness remains constant up to 20 February when floe1 breaks. Simba_2015f stops working and SIMBA_2015a features basal melt events corresponding to temperature changes in the ocean. The consistency of the 3 interfaces estimate is validated with the thermal diffusivity proxy and the vertical and temporal derivatives of temperature. - The ocean heat flux is derived from the latent heat flux which is directly proportional to the change in time of the ice/ocean interface depth and the conductive heat flux in the lower portion of the ice estimated 6 cm above the ice/ocean interface. The ocean heat flux values for SIMBA_2015a and SIMBA2015f range from -50 to 350 W/m2, and -50 to 150 W/m2 respectively, while the basal melt events associated with ocean temperature increase stand out in SIMBA_2015a.   The SIMBA data are available through the Norwegian Polar Institute’s data center (https://data.npolar.no/dataset/6ed9a8ca-95b0-43be-bedf-8176bf56da80) and the method of interface detection is thoroughly described in Provost et al. (2017). Note that all time series have been smoothed with a 36-h running mean.   Provost, C., N. Sennechael, J. Miguet, P. Itkin, A. Rosel, Z. Koenig, N. Villacieros-Robineau, and M. A. Granskog (2017), Observations of flooding and snow-ice formation in a thinner Arctic sea-ice regime during the N-ICE2015 campaign: Influence of basal ice melt and storms, J. Geophys. Res. Oceans, 122, 7115–7134, doi:10.1002/2016JC012011.